+86-592-7103069 sales1@kemus-valve.com
Categories
Contact Us

Xiamen Kemus Valve Co.,Ltd
Add: 5 floor, Zhimingxing Technology Building No 18, Honglian West Road, Siming District Xiamen China
Tel:+86-592-7103069
Mob:+8618359108305
E-mail: sales1@kemus-valve.com

Gate Valve

2 Inch Gate Valve

2 Inch Gate Valve

Wedge Gate Valve Design standards: API 600、GB/T 12234 DN: 2 "-48", DN50-DN1200 PN: Class150-Class1500 Body material: carbon steel, stainless steel, alloy etc. Operation: manual, gear, motor etc. The trim of wedge gate valve is wedge, which is vertical to medium flow direction...

Send Inquiry Chat Now


WEDGE GATE VALVE



Design standards: API 600、GB/T 12234

DN: 2 "-48", DN50-DN1200

PN: Class150-Class1500

Body material: carbon steel, stainless steel, alloy etc.

Operation: manual, gear, motor etc.


The trim of wedge gate valve is wedge, which is vertical to medium flow direction. Gate valve can only be fully open/close, and can not be used as adjusting valve. Wedge gate valve can be a unique type called inflexible disc; and can also be a flexible wedge

Gate valve under low pressure occasion, disc is forced to set to guarantee sealing; while disc is forced to contact another seat by high pressure condition. There is a slot structure inside the cavity to make sure the disc will not rotate under pressure, and also guarantee there is no friction before close position between seat and disc, thus reduces frictions on sealing face


Wedge gate valve has following advantages

1Small flow resistance, sealing face suffers less flush and corrosion.

2 Low torque operation, easy operation

3 Direction of medium is not limited, not generate disturbed flow, and not reduce medium pressure.

4 Simple structure, short face-to-face dimension, process precisely and widely applicable


Wedge gate valve of KEMUS has following advantages

1. Product fabrication is strictly according to API 600, full port design, on full open position, valve disc is higher that flow direction to guarantee flow smoothly, reduce pressure loss, high transmission efficiency.

2. For carbon material valve, seat is forged, high density, good sealing capacity. Sealing face use 13Cr or Stellite hard alloy material, overlay net thickness is over 2mm, valve seat is threaded or welded on the valve body, easy to maintain and dissemble.

3. Adopt rising stem, stem and disc is connected by a T shaped groove, T head and stem is forged together to guarantee enough connection strength. Flexible disc structure can avoid stuck caused by heat inflation

4. Back seal design will protect packing when valve is fully opened. Packing is flexible graphite, good sealing capacity, and also venting system is available. Packing bush and gland are ball structure, pressure process will enable the stem to automatically centralized, avoid stem stuck.

5. Bolted bonnet structure and thick hex nut fastening parts will ensure reliable function. Gasket adopt flexible graphite twist stainless steel or octagonal ring to get good sealing effect

6. Top entry nut design assures that, when the valve is open, even if demount the hand-wheel, stem and disc will not fall down. Stem is made by Aluminum bronze, and both sides set bearing, all this made the valve easy to operate.


Factory


factory picture


HTB1ofeveJHO8KJjSZFtq6AhfXXaK


wedge-gate-valve201811091013554501648

1542254773(1)